KAN-therm installation boxes

Distributors for surface heating shall be mounted in special installation boxes available in three versions: surface– mounted, embedded and clad with glazed tiles.

Due to the design of boxes for floor heating distributors can be mounted with or without a mixing device. In boxes there is also room for electrical strips. Electrical strips are attached by screws, which enter into special holes in a mounting strip in the upper part of a box. The Table below allows a fast selection of boxes depending on the distributor type, basic equipment and the way of connection:

Box type	Code	Height [mm]	Width [mm]	Depth [mm]	Number of circuits
Box type	Code	Height [mm]	Width [mm]	Depth [mm]	OP distributor	OP+Set-P/Set-K distributor	OP distributor with a mixer
SWN-OP-10/3	1100-OP	710	580	140	2-10	2-7/2-6	2-3
SWN-OP-11/7	1110-OP	710	780	140	11-13	8-11/7-10	4-7
SWN-OP-15/10	1120-OP	710	930	140	14-15	12-14/11-13	8-10
SWPG-OP-10/3	1300G-OP	710	580	110-165	2-10	2-7/2-6	2-3
SWPG-OP-11/7	1310G-OP	710	780	110-165	11-13	8-11/7-10	4-7
SWPG-OP-15/10	1320G-OP	710	930	110-165	14-15	12-14/11-13	8-10
SWP-OP-10/3	1300-OP	750-850	580	110-165	2-10	2-7/2-6	2-3
SWP-OP-11/7	1310-OP	750-850	780	110-165	11-13	8-11/7-10	4-7
SWP-OP-15/10	1320-OP	750-850	930	110-165	14-15	12-14/11-13	8-10

OP distributor – distributor for series 51A, 55A, 71A and 75A floor heating
OP + Set-P/Set-K distributor - distributor for series 51A, 55A, 71A and 75A floor heating with Set-K angle valves or straight valves type Set-P (2-7/2-6 – number of circuits with Set-K valves/number of circuits with Set-P valves),
OP distributor with a mixing device – distributor with series 73A and 77A mixing device.